- Joined
- Dec 3, 2013
- Messages
- 1,844
I am in the middle of a CNC conversion of a R45 clone mill. The mill came with power z-axis and a power table feed. I have moved the machine controls to another enclosure and have removed the motor contactors and switches for the z and table motors since I will no longer be using them. When I moved the controls and wiring I left most everything connected. Upon reconnecting the power I cannot get the motor contactor to energize. I'm pretty much out of my realm on chasing this down. I have 220vac to the contactor and transformer input. On the transformer output I get 13.9vac to terminal 31 and 6.2vac on terminal 30. If I understand the label correctly I think I should be getting 24vac at 30 & 31? Everything worked fine prior to disconnecting and reconnecting. Below are pictures of the original installation and the new enclosure installation. any help would be appreciated.
Jay
Jay