- Joined
- Oct 9, 2014
- Messages
- 465
The old Swedish LMW rotating centre still have good bearings but the tip is quite worn. So I ordered a high end centre (claimed) from India that is specified for CNC usage (high RPM and loads) and crossed my fingers... The bearings and seals are Made in Germany. It looks a lot better than I could wish. Larger than the old centre, which is not small by any means, and the look and feel of the new centre is very good.
The specs. guarantees 0,015 mm run out but the test protocol shows 0,002 mm (less than 0,0001 inch) which is extremely good if correct.
The specs. guarantees 0,015 mm run out but the test protocol shows 0,002 mm (less than 0,0001 inch) which is extremely good if correct.
Last edited: