I was cutting a groove in aluminum and while moving the table along the x axis I noticed the groove was way off course. I stopped the mill and its showing it went off by 2+ mms. The whole head is now cutting crooked diagonally and is "north" 2 mms from where I started.
I have dro sensors on all the axes and none of them show anything having changed.
I trammed the head and its not off much. I know I was pushing it but without tearing the whole thing apart for nothing what could have happened?
I have dro sensors on all the axes and none of them show anything having changed.
I trammed the head and its not off much. I know I was pushing it but without tearing the whole thing apart for nothing what could have happened?