Need more tool holders

[better-lathe-than-never]

I just purchased a small benchtop lathe JET BD920N from a local guy here in the Denver/Boulder area. The Previous Owner replaced the tool post with an aftermarket QCTP (see pics below). Few things about it: 1) It only has three tool holders, and I could use about 2 more; and 2) It's very small and appears to be less rigid than the original.

What size is this QCTP, there is no markings on it of any kind - made of anodized aluminum about 1 3/4'' on each side. If I know what size it is, I can start looking for additional tool holders.

Also, I don't want a honking big one, but I'd consider just replacing it with something a little larger and more stout - what size should I be looking for that would fit my machine? Not yet well versed in all those namings (0XA, AXA, BXA., etc..)

Edit: the compound platform with the stud is 2'' and 3/16 square.

Links would be appreciated.

 

[MrWhoopee]

Looks like one of these

https://www.amazon.com/dp/B07BF8NDNZ

An AXA is supposed to fit 6-12" lathes.

 

[woodchucker]

Looks like one of these

https://www.amazon.com/dp/B07BF8NDNZ

An AXA is supposed to fit 6-12" lathes.

that's a good hit, and it has sizes so he can see if they are a match to his.

looking at that cross slide, an AXA might be too big.

 

[better-lathe-than-never]

Looks like one of these

https://www.amazon.com/dp/B07BF8NDNZ

Yeah, I think that's it. I'll check the dimensions to be sure but it looks like what I got. Good find, sir.

 

[better-lathe-than-never]

looking at that cross slide, an AXA might be too big.

That platform is 2 3/16'' square

 

[BROCKWOOD]

Might be 0XA - but links posted above will help you narrow that down. In the smaller sizes, Shars & others offer individual tool holders at reasonable prices & they come in every flavor too.

I went with BXA & ended up making my extras with a dovetail cutter from 'Randy Richards in the shop'.

 

[Ulma Doctor]

The OXA is too small and gives up too much rigidity, IMO
The AXA is a better choice, hands down

 

[better-lathe-than-never]

Will AXA fit my 2 3/16'' platform?

 

[better-lathe-than-never]

Will AXA fit my 2 3/16'' platform?

Or will it look like a gorilla sitting on a bar stool?

 

[pdentrem]

I had the O size on my 10” Atlas and moved up to the AXA and the tools were much better held vs the OXA.
Pierre