- Joined
- Jul 26, 2014
- Messages
- 93
Hello All;
I purchased a used lathe and it came with a 3-HP 3-Phase motor. I live in Thailand and the power here is 220 Volt 50Hz.
The motor had been set up to run 380 Volts 3-Phase and try as I could I could not find anyone here to switch the motor back to 220 Volts 3-Phase as the plate from the motor was missing. So what I had to do was to Purchase a VFD that was capable of taking in 220 Volts AC and then changing it to 380 volts 3-Phase. I checked with several people and I was advise to purchase this model Huanyang GT Series Inverter Model #HY04D23B-T.
I have now wired up the inverter to the lathe and have tried to set up the parameters so the unit will run in its basic mode by using the front panel of the VFD. However I cannot get the unit to start the motor as something is wrong or most likely I have not set up the VFD correctly. I am including information on the motor as well as images I took from the VFD and the user’s manual.
If someone could please walk me through the set up slowly it would be greatly appreciated.
My Motor:
The motor is a Mitsubishi Superline motor and is listed as being from Japan, I think.
It says: Three Phase Induction Motor.
3HP 4 Pole Type SB-E
JIS C 4004 Frame 100L
Hertz 50 Rotor C
Voltage 220/ 380 Ins. Class E
AMP 8.7 / 5.0 Rating Con
RPM 1420 Amb. Temp 40Degrees C
Code H
Weight 28Kg.
Bearing 6206ZZ & 3205ZZ
Here are images of the VFD and Manual that I hope might help you in getting me started?
I will be happy to provide any other information that you might require to get this unit running!
Best Regards
Al
I purchased a used lathe and it came with a 3-HP 3-Phase motor. I live in Thailand and the power here is 220 Volt 50Hz.
The motor had been set up to run 380 Volts 3-Phase and try as I could I could not find anyone here to switch the motor back to 220 Volts 3-Phase as the plate from the motor was missing. So what I had to do was to Purchase a VFD that was capable of taking in 220 Volts AC and then changing it to 380 volts 3-Phase. I checked with several people and I was advise to purchase this model Huanyang GT Series Inverter Model #HY04D23B-T.
I have now wired up the inverter to the lathe and have tried to set up the parameters so the unit will run in its basic mode by using the front panel of the VFD. However I cannot get the unit to start the motor as something is wrong or most likely I have not set up the VFD correctly. I am including information on the motor as well as images I took from the VFD and the user’s manual.
If someone could please walk me through the set up slowly it would be greatly appreciated.
My Motor:
The motor is a Mitsubishi Superline motor and is listed as being from Japan, I think.
It says: Three Phase Induction Motor.
3HP 4 Pole Type SB-E
JIS C 4004 Frame 100L
Hertz 50 Rotor C
Voltage 220/ 380 Ins. Class E
AMP 8.7 / 5.0 Rating Con
RPM 1420 Amb. Temp 40Degrees C
Code H
Weight 28Kg.
Bearing 6206ZZ & 3205ZZ
Here are images of the VFD and Manual that I hope might help you in getting me started?
I will be happy to provide any other information that you might require to get this unit running!
Best Regards
Al