Matt- Since you are here on the boards it saves me a call tomorrow
Question about the power connection. I am wired in my shop for a nominal 240VAC. The manual states on page three that the lathe requires 240VAC 60Hz, but then on page five it says as shipped it is 220VAC with a recommendation to alter the connections to the 24VAC transformer. However, it doesn't say what to alter. Obviously, I don't want to let the magic smoke out of the transformer
Do you have a line diagram or pictures of how to wire the transformer for a nominal voltage of 240VAC?
Also, the machine came with wiring already in place to connect to a disconnect switch. The wire color is black, brown, and yellow with a green stripe. Just to be clear, the yellow/green stripe cable is for ground correct and not a neutral?
Thanks Matt.
Question about the power connection. I am wired in my shop for a nominal 240VAC. The manual states on page three that the lathe requires 240VAC 60Hz, but then on page five it says as shipped it is 220VAC with a recommendation to alter the connections to the 24VAC transformer. However, it doesn't say what to alter. Obviously, I don't want to let the magic smoke out of the transformer
Do you have a line diagram or pictures of how to wire the transformer for a nominal voltage of 240VAC?
Also, the machine came with wiring already in place to connect to a disconnect switch. The wire color is black, brown, and yellow with a green stripe. Just to be clear, the yellow/green stripe cable is for ground correct and not a neutral?
Thanks Matt.