PM-833TV power switch...

[davidpbest]

I would put spade connector on the end of the wire, crimp it an be done.
I will wait for the crimp vs solder debate to begin....

I laughed at your mention of the debate, but sure enough, here is begins. What a riot.

 

[davidpbest]

When you say not just closed with pliers are you talking about soldering as well? As far as a 30 amp wall switch......this is the one I was looking at.

View attachment 364600

That exactly the same switch I use to toggle power to the controls and VFD on my PM1340:

 

[tq60]

Just be sure correct number of poles.

SPST okay for 120 volts, DPST for 240 volts

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[Tipton1965]

That exactly the same switch I use to toggle power to the controls and VFD on my PM1340:

View attachment 364658

The wall switch seems like the best idea. That is the route I'm going to take.

 

[Tipton1965]

Got the switch installed. Wired it backward so the light was on all the time. Got it wired correctly now so the light only comes on when it's in the on position.