- Joined
- Jun 29, 2014
- Messages
- 4,065
Here's a picture of the spool holder insert, still on the sheet. Rather low stringing, at least compared to the other TPU. Nothing that won't clean up with some hot air. Exterior is very good looking. This GT-3 seems to be working for me. Or at least this spool is... Second is now printing on the opposite corner of the sheet.
View attachment 483404
That honestly looks pretty darn good.
I don’t know how to remove the stringing, but I expect pullback settings adequate enough to reduce or eliminate it would slow the program down substantially. Even then, TPU strings are so fine and so sticky I don’t see how they could be eliminated outside of a base mode print.
Sent from my iPhone using Tapatalk