Seeking Advice on Atlas No. 700 Taper Attachment

Here’s the pin.
1e0f6bb446965d347c6a3daa353ac8d2.jpg



Sent from my iPhone using Tapatalk
 
That is indeed a 700! Thanks for the pics!

Ultimately what I need is dimension A in the pic below. It's the distance from the top of the lathe bed to the top of the clamp.

d2854c8dd63569409106f7f13ddae9eb.jpg
 
And the pin is a slop free fit into the slot in the clamp I assume.
 
A = .2765 according to my surface plate and Starrett digital height gage...... sorry if all the pics are frustrating you.


Sent from my iPhone using Tapatalk
 
The pin is a snug fit. No slop, correct. Do you need dimensions for the draw bar?


Sent from my iPhone using Tapatalk
 
Awesome! Thanks you so much!

I got this from the download section of the forum.

CBC3FB28-DE7A-4A67-B10B-A79878DECE55.png

As far as I can tell this is adequate to reproduce the part.

Thanks again! This was a great help!
 
Well, I still don't know for certain whether the gib sits straight up and down like the carriage gib on any Atlas lathe does or laid over at an angle like the cross slide gib. But the front edge of the 10-702 Guide Bar is straight up and down, cut at 90 degrees to the top and bottom. So the 10-701A Bracket probably only has half of a dove tail, cut on the back side.
 
You must log in or register to reply here.
Back
Top