- Joined
- Apr 25, 2013
- Messages
- 13
I like to round over edges on parts I make and when using a radius cutter I always end up going to far
into the wall of the part. Is there a way to zero out the cutter so I can use my DRO to avoid that. There has to be some obvious solution I that have overlooked. Thanks in advance for any responses.
Peace
Greg
into the wall of the part. Is there a way to zero out the cutter so I can use my DRO to avoid that. There has to be some obvious solution I that have overlooked. Thanks in advance for any responses.
Peace
Greg