Thanks fo all your input on this thread.
BTW, Son tells me he is the armorer for the dept.
I found a Kolbalt driver set and a Craftsman metric set and modified the 3/16 and 5 mm drivers to the .271 OD as suggested. I also squared the face of the tools to remove some of the rounding off, hopefully it will prevent slipping. Sending them and the stag handled pin tool out today. Hope he likes them!
The bench block will have to wait.
Chuck
BTW, Son tells me he is the armorer for the dept.
I found a Kolbalt driver set and a Craftsman metric set and modified the 3/16 and 5 mm drivers to the .271 OD as suggested. I also squared the face of the tools to remove some of the rounding off, hopefully it will prevent slipping. Sending them and the stag handled pin tool out today. Hope he likes them!
The bench block will have to wait.
Chuck