Started using the new ACRA

Aukai

H-M Supporter - Sustaining Member
H-M Platinum Supporter
Joined
Oct 4, 2016
Messages
4,726
I got the R8 alignment pin out this afternoon, and got about half way through a pile of 316 SS gaff handles I need to drill out to 1/2". 1/4" pilot then 1/2" through hole, I did spin the 1/2" bit twice on the break through of the bottom hole.
 

Eyerelief

Registered
Registered
Joined
Apr 28, 2021
Messages
110
Those handles look really nice. Woul like to see one with the business end installed (and maybe a little fish juice on it)
 

Aukai

H-M Supporter - Sustaining Member
H-M Platinum Supporter
Joined
Oct 4, 2016
Messages
4,726
Thank you...
 

mmcmdl

H-M Supporter - Diamond Member
Staff member
H-M Lifetime Diamond Member
Joined
Jan 31, 2016
Messages
5,916
That mill is too clean ! :cautious:
 

mmcmdl

H-M Supporter - Diamond Member
Staff member
H-M Lifetime Diamond Member
Joined
Jan 31, 2016
Messages
5,916
Where are your chips ? :big grin:
 

Aukai

H-M Supporter - Sustaining Member
H-M Platinum Supporter
Joined
Oct 4, 2016
Messages
4,726
Circular file, that just the floor, the rest is under the paper towels...
 
It can take up to an hour for ads to appear on the page. See our code implementation guide for more details. If you already have Auto ad code on your pages there's no need to replace it with this code
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock