E
ecdez
Forum Guest
Register Today
I picked up a TEMCO phase converter a few months ago and am finally getting around to installing it.
Here's the first issue I noticed and thus my first question.
If you look at page 5 in the instruction manual (http://attachments.temcoindustrialpower.com/Data_sheet/XR11_Data_Sheet.pdf) it shows that the single phase side is grounded but the 3 phase side is not. I've read a few things that say that 3 phase is not required to be grounded. OK, fine. I look at my machines though and they have plugs with 4 prongs. What's a guy to do?
Here's the first issue I noticed and thus my first question.
If you look at page 5 in the instruction manual (http://attachments.temcoindustrialpower.com/Data_sheet/XR11_Data_Sheet.pdf) it shows that the single phase side is grounded but the 3 phase side is not. I've read a few things that say that 3 phase is not required to be grounded. OK, fine. I look at my machines though and they have plugs with 4 prongs. What's a guy to do?