- Joined
- Aug 13, 2020
- Messages
- 1,342
I bought an ER32 collet set. It came with an MT3 adapter and about six collets. I was just check to see if I'd like them. I liked them so much, I got frustrated a couple of times when I had an end mill to hold, but it fell between the sizes I had.
Now, I'm looking to build and adapter for the Sebastian lathe, and thinking that I might want to go with ER40, since my spindle will pass through 1 5/8". But, if I'm going to buy another set, even if it is the cheap set, I'd prefer there not be gaps in the holding range.
But, what would a full "able to hold anything in the range" set look like?
Now, I'm looking to build and adapter for the Sebastian lathe, and thinking that I might want to go with ER40, since my spindle will pass through 1 5/8". But, if I'm going to buy another set, even if it is the cheap set, I'd prefer there not be gaps in the holding range.
But, what would a full "able to hold anything in the range" set look like?