Yeong Chin YCM 1 1/2VS

ejsonline

Registered
Registered
Joined
Oct 26, 2018
Messages
2
Hi guys, I'm new to this site so please forgive me as I figure out the correct approach. I'm looking for info to assist rebuilding my mill, or perhaps some diagnostic tips to establish what repairs are required. Sounds like a worn bearing but not sure, when milling.
Thanks
 

markba633csi

Registered
Registered
Joined
Apr 30, 2015
Messages
4,710
Hi, is this a Rong Fu style mill? A picture would help
A rebuild can range from very involved to very minimal- what did you have in mind and why? Spindle bearings are usually not difficult or expensive
You may need a press however
mark
 
It can take up to an hour for ads to appear on the page. See our code implementation guide for more details. If you already have Auto ad code on your pages there's no need to replace it with this code
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock