- Joined
- May 2, 2021
- Messages
- 330
Snort laugh. Your a good man. Thanks - pictures worth a 1000 words sorta thing... Now I get it. Nice solution - and nice hand wheel!You made me get out of my chair and go out the the shop and tear my mill apart, took the better part of 2 minutes
Ahhh! got it.tighten the bolts, the end rings get closer together, which forces the OD ring out, and the ID ring in.
Shaft collars! why didn't you just say so!Note: set collar, also called shaft collar.
Ok - some good ideas here. I will take on board and should be able to solve.
Found these while I was searching the corners of the internet earlier today.
Thought they might look nice.
Perhaps I could use them to run a lip seal around the shaft as well to keep bad things out.
Wide one would be X.
Other Z.
Cast aluminum.
Will keep in bank until I get closer to determining what I am going to do about the communist gray my machine is coated in. Enough to depress a man on a bad day of milling.