Drive the brake pivot stud through the housing and the brake fingers like this. You can leave the snap ring on the end.
Cleaned up end/top view of lower belt housing.
Cleaned up bottom view of lower belt housing.
Brake operating finger pivot stud and brake fingers.
Drive the brake pivot stud through the housing and the brake fingers like this. You can leave the snap ring on the end.
The stud gets removed by driving it through the housing with a punch and a hammer. (remove set screw first!)
Remove this set screw on the bottom side of the housing. This screw holds the brake operating finger pivot stud.
This is the end of the brake lever pivot stud...
expressline99

Drive the brake pivot stud through the housing and the brake fingers like this. You can leave the snap ring on the end.

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
427
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
400
Flash
On, fired
Filename
DSCN5433.JPG
File size
2.2 MB
Date taken
Sat, 08 April 2017 2:36 PM
Dimensions
3648px x 2736px

Share this media

Back
Top