- Joined
- Sep 8, 2019
- Messages
- 4,392
My 220V, 3 phase lathe is coming in a few days. It is a 5HP machine. I have my 10HP RPC all ready to go.
The good news is that my RPC already has a female outlet (I will post a picture), so all I need to do is connect the wires from my new machine to the male connector (I will post a picture).
Ideally, the machine would come with a male plug already on it. However, I anticipate having to connect the wires to my male plug. As far as I know, maybe the machine will come with no plug or wire.
Understand that I am only asking about the connection from RPC to the lathe. The connection from the wall to the RPC (including consideration of breaker sizes) has already been taken care of.
The good news is that my RPC already has a female outlet (I will post a picture), so all I need to do is connect the wires from my new machine to the male connector (I will post a picture).
Ideally, the machine would come with a male plug already on it. However, I anticipate having to connect the wires to my male plug. As far as I know, maybe the machine will come with no plug or wire.
Understand that I am only asking about the connection from RPC to the lathe. The connection from the wall to the RPC (including consideration of breaker sizes) has already been taken care of.
Last edited: