- Joined
- Sep 29, 2017
- Messages
- 2,251
So I made the gear. Don't get it,don't understand it and don't know what to do. I now have a 57 tooth gear. The gears mesh on the table.
But the overlap by about 2mm on the lathe. The 95 tooth gear OD must be 194mm,and it is,but it is like something is still too big.
The center distance is set,you can't change it. It according to calculations it must be 152mm,and it measures 150, so there lies the 2mm I am talking about. So now the only thing I can do in my opinion is to make afset pin so I can adjust the big gear.
I guess about 2mm offset would be fine or what do you guys think I must do with this whole situation?
But the overlap by about 2mm on the lathe. The 95 tooth gear OD must be 194mm,and it is,but it is like something is still too big.
The center distance is set,you can't change it. It according to calculations it must be 152mm,and it measures 150, so there lies the 2mm I am talking about. So now the only thing I can do in my opinion is to make afset pin so I can adjust the big gear.
I guess about 2mm offset would be fine or what do you guys think I must do with this whole situation?