2021 POTD Thread Archive

@woodchucker what you doing that for?
its a brake for the quill. the way Clausing did it for the 8520-8530 was it squeezed the casting to lock the quill. It was a pain in the ass to set. And required a good gronk.

This split collet is how its done on the BP... and it's a flip, not much effort. No more slipping quill.. just lock it and work. more than a few pieces were ruined by the lock not holding. This holds real nice.. if I had a second mill it would have been a cake walk, but having a small lathe and just a drill press made this a job.
 
Today i spent all my spare time helping family members with their cars. First was my brother, he parked to wait for his children to finish school with his headlight on and the astra would not start. That wouldn't be too bad just a jump start but it's raining all day very hard. And like any school the line of vehicles was very long and he was blocking one lane, so i push him bumper to bumper straight in the school playground up to the lean roof and pull up from the other side that way i did not get very wet and jump starter him. It took more than an hour because of the traffic. After getting home i put my overalls to start working on the little niva but my cousin call he drove in standing water and locked up his engine on the highway in the rain. So i headed over there also push him bumper to bumper to the first petrol station. He is also driving 90's diesel peugeot, i know those engine are tough so i went in the petrol station bought a cheap wrench set for 4$, unbolted the glow plugs he crank it it shoot out lots of water, i also removed his air filter and reinstall the glow plugs. The thing fired up on the very first crank, it seems to have a noise perhaps he bent couple of the connecting rods but he was able to drive it home. Got back home then my father called he's got a flat tire. I grabbed my cordless impact and a 19mm socket, he was close but there was no escaping the rain changed his tire and send him on his way, his tire seems to be in a vacuum, no idea why. After this i needed to warm up and dry up.
View attachment 388738
you need a new family :grin: One that doesn't take advantage of you and your mechanical abilities...
Either that, or they should bring a wheel barrow full of money.
 
@woodchucker i know exactly what you mean now. Yes the lock for the quill is poopy. I havent had problems with it yet but thats a good source to go back on.
 
Thanks for the idea. Did you need to take the head off to do this project?
 
Here's a quick little project I made today. My granddaughter's new last name since her wedding last year is 'Grant'. I made this desk nameplate from a piece of scrap aluminum plate. The base is made from some leftover black Delrin. Her husband will keep it on his desk at work.

Any guesses where the 'Grant' part came from? (Hint: Street rodders will have an advantage.)

Regards,
Terry

IMG_1905.jpgIMG_1906.jpg
 
Here's a quick little project I made today. My granddaughter's new last name since her wedding last year is 'Grant'. I made this desk nameplate from a piece of scrap aluminum plate. The base is made from some leftover black Delrin. Her husband will keep it on his desk at work.

Any guesses where the 'Grant' part came from? (Hint: Street rodders will have an advantage.)

Regards,
Terry

View attachment 388848View attachment 388849

Very nice!... and I know where the center piece came from... very creative!

-Bear
 
Back
Top