- Joined
- Nov 20, 2014
- Messages
- 96
I got a nice clear picture of the tag, but can't post it. I've cropped it down as small as I can and it still says it excedes the limit to post.
I got a nice clear picture of the tag, but can't post it. I've cropped it down as small as I can and it still says it excedes the limit to post.
Here is a transformer set up for make 3 ph to 2 ph
If you can make this type of motor to single phase just like your AC on your home
Dave
I went through my transformer book and I could not find a single phase Scott type connection, it just ends up as a single phase buck and boost.
You could do it with the proper capacitor inductor connection but the size on the capactiors would need to vary based on load. This would be similiar to a static three phase convertor that someone else had mentioned.
I think your better off to replace the motor or maybe go with a high end treadmill motor. I run a treadmill motor on my 12 x 36 lathe and have no problems.
Art B
PS That motor may have some value to a college as a lab motor.
Save it as a jpeg and it should post
Art B
It's already a jpeg
I got a nice clear picture of the tag, but can't post it. I've cropped it down as small as I can and it still says it excedes the limit to post.
As a new(er) member you are limited as to how much you can upload. I don't have access to change your status to allow your up load. But you can email a picture to me an I can post it for you. My email is in my signature below.