- Joined
- Dec 5, 2017
- Messages
- 464
The collet draw bolt (proper nomenclature?) on my Grizzly mill has an 8mm square head. The provided 8mm open end wrench works, but a T-handle socket would be MUCH faster and easier.
I've searched fairly extensively for an 8mm female square socket without success. I'd be happy to make my own if I could find the material or a 1/4 or 3/8 drive socket.
Sources?
I did notice that the T wrench for my acetylene tank is REAL close, I could possibly buy one of those and file the socket out to fit. Tedious, but doable.
I've searched fairly extensively for an 8mm female square socket without success. I'd be happy to make my own if I could find the material or a 1/4 or 3/8 drive socket.
Sources?
I did notice that the T wrench for my acetylene tank is REAL close, I could possibly buy one of those and file the socket out to fit. Tedious, but doable.