- Joined
- Jun 17, 2015
- Messages
- 16
That's good to hear - I've been doing cuts on tubing and angles using a 4 1/2" grinder. I've gotten pretty good at it - but I can never get the kind of accuracy you're describing
Plus it makes a mess - I try to always do it outside the shop so I'm not shooting hot sparks and steel dust everywhere. Using a bandsaw would make it so I can do the cuts inside and also keep the mess down.
Plus it makes a mess - I try to always do it outside the shop so I'm not shooting hot sparks and steel dust everywhere. Using a bandsaw would make it so I can do the cuts inside and also keep the mess down.