- Joined
- Jan 14, 2016
- Messages
- 86
I have a project, a set of darts, that involves making scallop patterns. They will need to be in the range of 13mm on center. I think the best approach is to rough out on the lathe then use files to finish the profile.
I have been looking at the pin files which may work but in the long run they will probably need to be diamond as the final product will be done in tungsten. Does anyone have a suggestion for a good set in the $50 range?
I have been looking at the pin files which may work but in the long run they will probably need to be diamond as the final product will be done in tungsten. Does anyone have a suggestion for a good set in the $50 range?
Last edited: