For almost 3 months now the General (wife) has been nagging at me to get my haircut. I didn’t think it was a big deal (never have) & it most certainly wasn’t high on my priority list…in fact, I don’t recall it being on my list at all, to be honest.
Anyways, I was in the process of turning down some 5/8” o/d x 6” long 1144 rod when I apparently must have thought that this would be a good time to trim my hair, a-la “machinist-style”….I don’t recommend it.
....and there is a lot more than what you see sticking up wound around between live center & end of bar...
Scared the bejeezus out of me at first, then stared in disbelief for a minute at my handywork , then giggled for a bit at my stupidity & then finally thought about what could have transpired, which stopped the giggling immediately.
Being the type that, 1) learns best from a hand's-on approach, & 2) usually a quick learner, I've combined these two skills & come to the conclusion that you really do need to pay attention to your surroundings ALL of the time around a lathe...
I promised the wife I will get a haircut on my way home tomorrow!
Anyways, I was in the process of turning down some 5/8” o/d x 6” long 1144 rod when I apparently must have thought that this would be a good time to trim my hair, a-la “machinist-style”….I don’t recommend it.
....and there is a lot more than what you see sticking up wound around between live center & end of bar...
Scared the bejeezus out of me at first, then stared in disbelief for a minute at my handywork , then giggled for a bit at my stupidity & then finally thought about what could have transpired, which stopped the giggling immediately.
Being the type that, 1) learns best from a hand's-on approach, & 2) usually a quick learner, I've combined these two skills & come to the conclusion that you really do need to pay attention to your surroundings ALL of the time around a lathe...
I promised the wife I will get a haircut on my way home tomorrow!