- Joined
- Apr 10, 2014
- Messages
- 172
Has title suggests my PM 835 arrived today.
Nicole shipped it out Friday, with the idea that it would hit me here in Florida on Wednesday and then I could delay the delivery until Friday. But for some strange reason, it hit Florida on Sunday, and they delivered it today.
I wasn’t really ready, but fortunately my wife was home and the delivery driver took pity upon her and place it in the garage for me.
It was in a huge crate that looked like it could hold a family of four with even some room left for .furniture. The crate was so well put together, it took me quite some time with the shorts sledge in a crowbar even to take it apart.
Upon breaking it apart, my eyes were greeted by this beautiful huge machine. It is much bigger than I suspected it would be and I think it’s going to be a real challenge to get it off the pallet which appears quite built up
It appears to be a very well put together machine, what I can tell, finish seems pretty good on it . However, the lower part of the casting of the base has some rather rough holes in it that I think are for putting steel rods in and using a forklift to move it. Other than that , it is a beauty.
I’ve attached a few pics for everyone to see. It looks like it’s covered with a fair amount of grease and I think it’s going to take some work with some rags and some WD-40 to clean it up. More pictures are coming
Nicole shipped it out Friday, with the idea that it would hit me here in Florida on Wednesday and then I could delay the delivery until Friday. But for some strange reason, it hit Florida on Sunday, and they delivered it today.
I wasn’t really ready, but fortunately my wife was home and the delivery driver took pity upon her and place it in the garage for me.
It was in a huge crate that looked like it could hold a family of four with even some room left for .furniture. The crate was so well put together, it took me quite some time with the shorts sledge in a crowbar even to take it apart.
Upon breaking it apart, my eyes were greeted by this beautiful huge machine. It is much bigger than I suspected it would be and I think it’s going to be a real challenge to get it off the pallet which appears quite built up
It appears to be a very well put together machine, what I can tell, finish seems pretty good on it . However, the lower part of the casting of the base has some rather rough holes in it that I think are for putting steel rods in and using a forklift to move it. Other than that , it is a beauty.
I’ve attached a few pics for everyone to see. It looks like it’s covered with a fair amount of grease and I think it’s going to take some work with some rags and some WD-40 to clean it up. More pictures are coming
Last edited: