Hey Mike,
Have a question when you have time...
Standing in front of your 1340GT... what is the measurement from the left side of the left cabinet, to the right side of the right cabinet? Am working out the metal for a stand.
THX
John/GA
Hey Mike,
Have a question when you have time...
Standing in front of your 1340GT... what is the measurement from the left side of the left cabinet, to the right side of the right cabinet? Am working out the metal for a stand.
THX
John/GA
John, I will get you that measurement when I get home this afternoon. Just for clarification, you are not talking about the length of the chip tray, just the outside edge of the two base cabinets that the chip tray and lathe sit on, correct?
John, the outside dimension of the cabinets themselves is 64-3/4".
Hey Mike,
I followed your posts on your new machines. I have been on the fence about purchasing some machines but, after following you through your posts. I have decided to order from Matt. I am purchasing a PM 1340gt and a PM 935 T-S. So thank you for the good reviews. Do you have a schematic of your wiring for the VFD on your lathe? I could use alittle help in that area. I do not have the machines yet maybe February or March. and what model of the WJ200 are you using?
Thanks
JD