- Joined
- Jul 20, 2014
- Messages
- 1,386
Removing the bearings from the end plate is just a matter of using a punch from
a transfer punch set of the diameter that is just small enough to catch
the edges of the bearing, hold at an angle and holding the part in a vise, give it a couple
of good strikes. Sometimes you have to change the punch position to get the bearing out
evenly. it works w/o destroying the bearing.
a transfer punch set of the diameter that is just small enough to catch
the edges of the bearing, hold at an angle and holding the part in a vise, give it a couple
of good strikes. Sometimes you have to change the punch position to get the bearing out
evenly. it works w/o destroying the bearing.