Pm-25mv z-axis travel

[DavidR8]

I’m hoping someone with a PM-25MV mill will do me a favour and measure the total available travel of the head not including spindle travel.
Thanks!


Sent from my iPhone using Tapatalk

 

[erikmannie]

I’m hoping someone with a PM-25MV mill will do me a favour and measure the total available travel of the head not including spindle travel.
Thanks!


Sent from my iPhone using Tapatalk

I will do it first thing tomorrow morning. It is going to be very close to 13 inches.

 

[DavidR8]

I will do it first thing tomorrow morning. It is going to be very close to 13 inches.

Thanks Erik!


Sent from my iPhone using Tapatalk

 

[erikmannie]

I took out the collet & cranked ‘er down all the way. I will show pictures of it:

 

[DavidR8]

Thanks Erik, is that 13" of travel for the head?

 

[erikmannie]

The scale shows this. I am calling this 10 1/32”.

 

[erikmannie]

Thanks Erik, is that 13" of travel for the head?

I am still getting to the result...

 

[erikmannie]

So now I cranked it higher than I should have (past the zero). Here it is cranked up that high

 

[erikmannie]

The scale shows this. This is -3/32”.

 

[DavidR8]

So is it safe to say it's 10 1/8" total travel for the head?