- Joined
- Jul 2, 2014
- Messages
- 7,594
Nice job on that fitting, Alan!
Alan is aware of my design, Bob.Thanks for remembering.
Alan, I should think that making a T-slotted table would be simple. Rabbet an edge on two pieces of steel and plug weld them to a third piece that will form the bottom. Then make a miter gauge and you should be set.
mikey, could you please share your design? I'm thinking of building a 2x72 grinder and haven't seen it.
Thanks for adding the link here Mike for others who haven't seen it.Nothing special, Dan. Here's a link that shows the table: http://www.machinistblog.com/modifying-a-craftsman-2-x-42-inch-belt-sander-for-tool-grinding/