Group Project: Dividing Head - Organization and Design

I have the same chop saw. The thing is amazing.
Robert
 
Single pointing ACME isnt too bad. Check that you can hit the pitch: it's probably really coarse. Last one I did required gears on my Harding! And the retract didnt pull back enough...

Sent from my SM-G892A using Tapatalk
 
I am not sure why the section view on the Trunion Assy is missing from the drawing file.
Here is a new one of that sheet.
 

Attachments

  • DH AY002 Trunion AY - Sheet1.pdf
    101.6 KB · Views: 4
I just wanted to get a feel on everyones opinion. I checked on my parts which includes all of the indexing crank pieces which are parts 32-36. I can do most of the parts right from the start however my concern is the milling work. I cant get to doing the milling work atleast until maybe end of june depending on the weather. Now is everyone ok if with that amount of waiting time possibly if it does get held up on my side? I dont mind doing the work, in fact i want to do it but if it is a problem i understand then.
 
Brento said:
II just wanted to get a feel on everyones opinion. I checked on my parts which includes all of the indexing crank pieces which are parts 32-36. I can do most of the parts right from the start however my concern is the milling work. I cant get to doing the milling work atleast until maybe end of june depending on the weather. Now is everyone ok if with that amount of waiting time possibly if it does get held up on my side? I dont mind doing the work, in fact i want to do it but if it is a problem i understand then.
Click to expand...
I gotta think this is going to take a few months for all of us to build anyway, so I wouldn't sweat it.
 
if no one signs up for them i can do the plug brass and the handle. I can prob do the handle by hand if it isnt really critical.
 
Not much of the handle is critical.
 
Wow. The drawings look great! You guys picked a tough project to start on though.
Robert
 
It will be a tough project i am sure but it is going to be nice to have one built with alk of you guys instead of a mass produced one. Makes it all sentimental-y lol. I know the handle isnt critical but as long as that drill point is not critical i can do it by hand and save some time for others doing more important things.

Edit: any ideas for material yet or is that part of the last go through on the drawings.
 
You must log in or register to reply here.
Back
Top