- Joined
- May 25, 2016
- Messages
- 181
I'm sorry for posting, there must be dozens of posts on this topic, but I think I've found them all, and they don't apply to my mill.
I have a new (to me) enco mill drill. About 600lbs of coolness, and was able to move the motor jumpers to get it to run on 110v.
The ONLY issue is that the forward/reverse drum switch is backwards. I figured it would be easy - locate the capacitor/start winding, reverse the leads, and I'd be good.
Not so easy, apparently - my drum switch has 12 contacts, and without taking everything apart, there's no way I can map it out.
I'm hoping someone has an earlier enco mill/drill that uses the same reversing drum switch and 2HP Chinese motor. (4L-90-4, I believe)
I'll attach the pics that I have.
I have a new (to me) enco mill drill. About 600lbs of coolness, and was able to move the motor jumpers to get it to run on 110v.
The ONLY issue is that the forward/reverse drum switch is backwards. I figured it would be easy - locate the capacitor/start winding, reverse the leads, and I'd be good.
Not so easy, apparently - my drum switch has 12 contacts, and without taking everything apart, there's no way I can map it out.
I'm hoping someone has an earlier enco mill/drill that uses the same reversing drum switch and 2HP Chinese motor. (4L-90-4, I believe)
I'll attach the pics that I have.