OK, I've been using the thick pipe burying tape to protect the knurls during drilling operations. I did find a PDF for serial numbers. It does not have an exact year just a range of production.
Pipe tape is certified to be consistently 10 mils thick. That should make a nice soft pad that doesn't throw you off center! Good idea, better than a beer can.
I use Al & Cu to protect finished parts in the 4-jaw. I made "sets" for both ID & OD holding. Some people make nice cut out & formed slip on jaw protectors. I bought a sheet of Cu to make em too but I never get around to making them. Lol. They're not soft enough to fully protect the knurling on your Al bats though.
When I was making Ti beads & stuff I would make split collars out of delrin to protect knurling.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.