I took the motor off and removed both brushes, They are not the same, They are slightly different size and the one with the clamp on it the wire is twisted and almost disconnected. The one has a deformed spring and the metal cap on the end is missing two legs that slide into where the brush fits in the motor. I and going to remove the gear on the end of the shaft and disassemble the motor to see if I can see and internal damage, If not will order a set do brushes and caps
There should be a second picture of the motor which has two black spot on the housing, look like burns, Wonder how they got there
There was not voltage to the motor lead so I am guessing the board is also bad. I think the first thing to do if is see nothing fried inside the motor would be to get the brushes and caps and then see if motor will run hooked direct to 12vdc
gary
There should be a second picture of the motor which has two black spot on the housing, look like burns, Wonder how they got there
There was not voltage to the motor lead so I am guessing the board is also bad. I think the first thing to do if is see nothing fried inside the motor would be to get the brushes and caps and then see if motor will run hooked direct to 12vdc
gary