Grizzly told me they would ship today. I figure it comes in late Friday or Monday. My rigger should be back in town this weekend so I suspect we will have it sitting in shop sometime next week. I have made room for it, just barely. Probably be another week before its leveled and wired up, I am waiting to install lathe before doing the final overhead run of wire and drop down to motor. Running conduit on ceilings when you have a bad back blows, so I am waiting till lathe is here so I can drop it right where it needs to be. RFC and disconnect (fused) will be on wall about 10' away near panel. I should be able to run both lathes if needed, about 2 steps away from each other, across I bay of garage.
michael