I have been browsing the forums and have generated a couple of questions about my: 1) my 11" 1983 Logan Powermatic ,model 1110008L00H has a number of deficits: the feed screw was bent by some previous owner. I have located one that seems right, but wondered if anyone knows whether the 48" lead screw from an earlier 11" Logan would be the same as the Powermatic. I am assuming a straight used one would be better than a straighten(ed) one in terms of accuracy. 2) I read a long thread about the bearings in the headstock, their expense, special characteristics and a couple of same size substitutes and how expensive they were. I don't have the dimensions of what is in there as the parts book I have doesn't quite correspond to the machine I have which has 2 front bearings and one rear vs only two total. I am loath to tear it down without being sure I can find something that can work. I have an email into Scott at Logan, but haven't heard back. Any pearls about possible substitutes?
Thanks in advance
Thomas Moseley