Thanks NorseDave, I'm enjoying working on the Mill but it sure does take a fair bit of time.
In regards to the Miller 211. So far I've just been using small (2lbs) spools of .030 wire. I have quite a few small spools left over from my old welder I want to use up first. I haven't had any issues with them. I'll keep in mind that I may need to modify the 'axle' if I want to run the 10lbs spool at some point. Thanks for the tip.
In regards to the Miller 211. So far I've just been using small (2lbs) spools of .030 wire. I have quite a few small spools left over from my old welder I want to use up first. I haven't had any issues with them. I'll keep in mind that I may need to modify the 'axle' if I want to run the 10lbs spool at some point. Thanks for the tip.