- Joined
- May 18, 2015
- Messages
- 231
I purchased a 100 foot roll of 10/3 and started the install thinking the lathe would require a 30 amp breaker (not shown on their website). A couple days later I found it only used a 20 amp so I just kept going. The problems were due to limited access (I actually had to use small mirrors and hemostatic pliers in places) so I still would have had the same problems even with 12/3 wire. BTW, I stuck around this evening to work on the wiring and finished routing the wire through all the problem areas. I still have a lot to do, there won't be any more delays.