Bought some keyhole cutters (32) from @mattthemuppet2 and needed a way to keep them stored and organized.
Drew up the model in F360, and printed the trays out.
Drew up the model in F360, and printed the trays out.
You need trays.Got my taps “organized” into one of the new US General drawers. Was looking for a better system but decided I could just use what I have.
What material did you use for the chip shield behind your table? Mine's about shot; not sure what to buy.
Yes, I do. But this will have to do until you let me know where you got yoursYou need trays.
Was on the mill when I got it. Feels like some kind of silicone sheet. Really flexible and nice. I used Neoprene rubber from McMaster on my last mill.What material did you use for the chip shield behind your table? Mine's about shot; not sure what to buy.
Regards