View of the belt housing after you've removed the brake shoes. Here you can see the cam fingers simply open up without the shoes holding them together
Rotate the brake shaft so you can see the end of the roll pin. I just used the punch through the end as shown. Keep the punch handy.
"Mostly" drive out the roll pin in the brake shaft with a punch and hammer, This is holding the brake operating cam to the shaft.
Close up view of end of the brake lever shaft. I would show how the Brake lever is removed...but my brake lever is missing.
View of the belt housing after you've removed the brake shoes. Here you can see the cam fingers simply open up without the shoes holding them together
After you've removed the screw in the picture before this the brake shoes will lift right out... The cam fingers are holding the shoes apart here.
Remove this screw to start uninstalling the brake shoes.
Belt housing, lower end, close up of front bottom side.
expressline99

View of the belt housing after you've removed the brake shoes. Here you can see the cam fingers simply open up without the shoes holding them together

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
419
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5414.JPG
File size
2.2 MB
Date taken
Wed, 05 April 2017 7:51 PM
Dimensions
3648px x 2736px

Share this media

Back
Top