Rotate the brake shaft so you can see the end of the roll pin. I just used the punch through the end as shown. Keep the punch handy.
Grab the roll pin with some vise grips to remove it. Use the punch to hold the brake shaft still while you fight this thing.
Using the punch to hold the shaft while you remove the roll pin.
Should be able to drive the roll pin out this much...gotta grab it with vise grips next.
Rotate the brake shaft so you can see the end of the roll pin. I just used the punch through the end as shown. Keep the punch handy.
"Mostly" drive out the roll pin in the brake shaft with a punch and hammer, This is holding the brake operating cam to the shaft.
Close up view of end of the brake lever shaft. I would show how the Brake lever is removed...but my brake lever is missing.
View of the belt housing after you've removed the brake shoes. Here you can see the cam fingers simply open up without the shoes holding them together
expressline99

Rotate the brake shaft so you can see the end of the roll pin. I just used the punch through the end as shown. Keep the punch handy.

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
416
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5419.JPG
File size
2.2 MB
Date taken
Wed, 05 April 2017 7:56 PM
Dimensions
3648px x 2736px

Share this media

Back
Top