- Joined
- Jul 20, 2012
- Messages
- 1,242
Made an “Ink well” for Bondic adhesive.
Bondic is that adhesive that is liquid plastic until UV light hits it for a few seconds.
It comes with a squeeze tube applicator but sometimes it is better to dip in a drop applicator for very small things. They make a drop applicator set that fits Xacto like holders. Sometimes nice to be able to dip in an actual part to pick up plastic then hold for the UV light.
Bondic needs to be stored in the dark to avoid any UV until it is used.
The project was taking a half inch stainless steel disk and drilling and boring out down an eighth inch. Then I took a black aluminum pill container and parted it off in the lathe so it would be short.
It works well and has a rubber grommet for the top to keep it air tight.
Bondic is that adhesive that is liquid plastic until UV light hits it for a few seconds.
It comes with a squeeze tube applicator but sometimes it is better to dip in a drop applicator for very small things. They make a drop applicator set that fits Xacto like holders. Sometimes nice to be able to dip in an actual part to pick up plastic then hold for the UV light.
Bondic needs to be stored in the dark to avoid any UV until it is used.
The project was taking a half inch stainless steel disk and drilling and boring out down an eighth inch. Then I took a black aluminum pill container and parted it off in the lathe so it would be short.
It works well and has a rubber grommet for the top to keep it air tight.