I just got my 1340GT up and running. Been busy making parts for my side job.
Outboard spindle spider turned out well. Took a 3" aluminum bar stock, bored out .900" deep to fit snug over the spindle, then bored the rest to 1.5625" to match the inside diameter of the spindle. Cross drilled at 90", threaded 5/16-18 for my hex head cap bolts. I also cross drilled four smaller holes and threaded for some set screws. Turned out shnazzy.
Made a false center for truing bolts. Also turned out well and was my first threading job. I had concerns after reading the dial chart, and since I didn't want to butcher anything, I played it safe and went on "1" each time. Remington bolts are 1/2-13, and I didn't quite understand the whole chart. And, it was a Saturday. Turned out great.
Now all I have to do is figure out the whole posting of pictures here and i am golden.
Outboard spindle spider turned out well. Took a 3" aluminum bar stock, bored out .900" deep to fit snug over the spindle, then bored the rest to 1.5625" to match the inside diameter of the spindle. Cross drilled at 90", threaded 5/16-18 for my hex head cap bolts. I also cross drilled four smaller holes and threaded for some set screws. Turned out shnazzy.
Made a false center for truing bolts. Also turned out well and was my first threading job. I had concerns after reading the dial chart, and since I didn't want to butcher anything, I played it safe and went on "1" each time. Remington bolts are 1/2-13, and I didn't quite understand the whole chart. And, it was a Saturday. Turned out great.
Now all I have to do is figure out the whole posting of pictures here and i am golden.