- Joined
- Aug 29, 2013
- Messages
- 1,050
another issue i'm having, when clamping my piece into the vice, one end rises up.
how do i keep the piece flat??
Get a dead blow hammer similar to this:
http://www.harborfreight.com/2-1-2-half-lb-neon-orange-dead-blow-hammer-41798.html
Mount the part on parallels. As you tighten the vise and it starts to rise up, smack it down. Push or pull slightly on the parallels to ensure the part is sitting on them. Finish tightening the vise slowly and smack down as necessary.