- Joined
- Dec 15, 2018
- Messages
- 787
A while ago I made a post showing a hob I'd made to cut gear teeth. The teeth weren't deep enough on the prototype cutter. I was topping the gear teeth before I could get deep enough to get the correct measurement over pins. Made a second hob that worked great. The larger gear measured correctly and now meshes well at the correct center spacing.
![IMG_4444.jpg IMG_4444.jpg](https://www.hobby-machinist.com/data/attachments/307/307116-05a1b25ec7048a2bb3e0e166cb01e2f1.jpg)
The large gear is the first part of a future project. Will start a thread on it when I get going. A few other projects to get cleaned up first.
Greg
![IMG_4444.jpg IMG_4444.jpg](https://www.hobby-machinist.com/data/attachments/307/307116-05a1b25ec7048a2bb3e0e166cb01e2f1.jpg)
The large gear is the first part of a future project. Will start a thread on it when I get going. A few other projects to get cleaned up first.
Greg