BTW, don't start that grinder without ringing the wheels. You need to make sure they travelled well, and didn't get hit since it last ran.
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
What Did You Buy Today?
- Thread starter darkzero
- Start date
Thanks…I did not think about that…
Looks great. Very exciting!
New vise for the shop to replace my awful cheap big box vise. This vise is pretty slick!
Bought this rotary table on craigslist today.
Paid a little more than I should have, but he won... he would not negotiate.
He insisted it was a grizzly, but it's not, it's silver, not green, and no markings.
But it is a very nice unit. no crud inside, just grease... I'll probably replace the grease with Moly.
I can't get the bearings out of the center, so I'll just clean in place before regreasing.
Oil only on the points that have oil buttons.. It's missing a set screw for the gear release. it has one, but the second is open to the elements. I may just plug it.
6" I've needed one for a while, and my makeshift ways can come to an end.
Paid a little more than I should have, but he won... he would not negotiate.
He insisted it was a grizzly, but it's not, it's silver, not green, and no markings.
But it is a very nice unit. no crud inside, just grease... I'll probably replace the grease with Moly.
I can't get the bearings out of the center, so I'll just clean in place before regreasing.
Oil only on the points that have oil buttons.. It's missing a set screw for the gear release. it has one, but the second is open to the elements. I may just plug it.
6" I've needed one for a while, and my makeshift ways can come to an end.